Variant: 2 parts
With the 2-part variant, the downpipe bracket is available for new gutter systems.
The 2-part variant can be used for existing downpipes as well as for new roof drainage systems.
For existing downpipes, the old downpipe clamp must first be opened & removed and the downpipe detached from the house wall. Then you mount the back of the new 2-part downpipe bracket with 2 screws on the house facade. The downpipe is then hooked in and the panel (front) of the downpipe holder is slid on and fastened with screws.
A pictorial guide and further information can be found in our service area under the item "Assembly instructions".
Variant: 3 parts
With the 3-piece variant, the downpipe bracket is also available for your existing gutter system.
It is used when the downpipe cannot or should not be detached from the house facade.
The old downpipe clamp is removed from the wall with a flex and the new downpipe bracket in a modern design is attached to the existing downpipe.
For this purpose, the 2-part back is attached to the side of the downpipe. The downpipe is then hooked in and the panel (front) of the downpipe holder is slid on and fastened with screws.
A pictorial guide and further information can be found in our service area under the item "Assembly instructions".